Your basket is empty.

Added to Basket

BMS F Chassis 3.5" Slip-On N55 & B58 Exhaust Tips

$110.00 $99.00

Specification
Product Code BMS3LD6M19
Manufacturer Burger Tuning
Condition New
Weight 4Lb

Earn Reward Points: 99

Dollar Value of Points: $0.99

BMS F Chassis 3.5" Slip-On N55 & B58 Exhaust Tips

Fits 2012+ F Chassis BMW M135 (non-US), M235, 335, 340 and 435 vehicles only. Incuding XI.

BMS 3.5" Slip-On Exhaust Tips Applications:

BMW 1 Series (NON-USA MODEL ONLY)
• 2013+ BMW F20 F21 N55 M135 (*see below)

BMW 2 Series 
• 2014+ BMW F22 F23 N55 M235i/ix (*see below)

BMW 3 Series
• 2012+ BMW F30 F31 N55 335i/ix
• 2016+ BMW F30 B58 340i/ix 
• 2012+ BMW F34 GT N55 335i/ix

BMW 4 Series
• 2014+ F32 F33 N55 435i/ix
• 2014+ F36 Gran Coupe N55 435i/ix

Give Your Factory N55 / B58 Exhaust An Attitude Adjustment

Not for use with M-Performance exhaust systems.

The BMS 3.5" slip-on exhaust tips are the perfect choice for dressing up your factory exhaust outlets. Made from stainless steel and etched with the BMS logo these are sure to turn heads. Specially equipped with factory-like pressure clips so they go on easily and stay in place just like the factory tips. No ugly screws or clamps for a factory appearance. These easy to install exhaust tips are offered in a variety of colors and cuts that are sure give your factory BMW exhaust system a grand look. Not for use with M-Performance exhaust systems. Does not fit any E chassis vehicles or other F chassis vehicles other than those listed above. 

*F chassis M135 and M235 models will need to check your alignment pin before ordering. If your alignment pin is not straight up and down you can only get straight cut, no logo. 

Some early build M135 and M235 have an alignment pin that is rotated inward 45º, unlike the straight up and down alignment pin of the 335 and 435. If you get the logo tip, the logo or angle cut it will be turned 45º to the inside. 
 


To install remove your factory tips by pounding outward on the lower part of the tip with either a rubber mallet or a hammer. A small piece of wood can also be used between the hammer and the exhaust tip edge. This is done from under the rear of the car. Small medium taps will start the factory tip sliding off the actual exhaust pipe. Secure the tip before it comes off the end of the pipe with your hand. Make sure to keep it straight to not damage the inner spring clips. The cutout must be facing straight or at 45º depending on where your alignment dowell is. Slide the BMS slip-on exhaust tip straight over the factory exhaust pipe. Carefully push the tip straight on until it stops. The tips should completly hide the pipe edge. You may want to cover the edge of the tip with a folded towell and lightly pound with a rubber mallet.

 

Customer Reviews

This product hasn't been reviewed yet.

Write a review

Write Review

1 2 3 4 5
 

Verify you are a human

 
Please enter a valid email address.
This field is required.

© 2017 n54tuning.com