JB3 Software/Firmware






The above JB3 software is the latest software available. Please make sure you update your software as we release new software and firmware. Current software is 06/30/10.

A selection of the last few Firmware versions are available for download below. The files are compressed (ZIP) so just uncompress and load into the chip burning software or into your JB3 software. Check back often as the latest software/firmware will be posted here as it becomes available.

Latest firmware and interface ready for testing. Made some nice enhancements to low throttle input and added an adjustable field to let you set your desired boost levels per amount of throttle input. Many users have reported dramatically improved low throttle drivability.

YOU MUST SET YOUR PEDAL TARGET TO A DEFAULT VALUE UPON LOADING FIRMWARE. I SUGGEST 50% TO START.

Firmware changes:
1) Cleaned up low throttle boost targeting.
2) Added new user adjustable pedal target. 0% = stock boost until 75% throttle while 100% = full boost target at 50% throttle input. Settings of 30-70 seem to work best. 50 is default.
3) Removed passive bogfix as it was intermingled with the low throttle boost targeting. If you're a manual be sure to enable the active bogfix by setting it to 100%.


Interface changes:
1) Replaced lean cruise adjustable (was not in use) with new pedal target adjustable.
2) Added adjustable boost charting range under settings to allow rescaling up to 22psi for those who need it.


As always report any bugs or concerns to Terry/BMS via email @ terry@burgertuning.com. Thanks!

RS232_070410.HEX

1_40_G3_VENT.HEX
1_40_G2_VENT.HEX
1_41_FINAL.HEX

[iAG] Nulled 2008